Utility aircraft family From Wikipedia, the free encyclopedia
The de Havilland Canada DHC-3 Otter is a single-engined, high-wing, propeller-driven, short take-off and landing (STOL) aircraft developed by de Havilland Canada. It was conceived to be capable of performing the same roles as the earlier and highly successful Beaver, including as a bush plane, but is overall a larger aircraft.
The rugged single-engined, high-wing, propeller-driven DHC-3 Otter was conceived in January 1951 by de Havilland Canada as a larger, more powerful version of its highly successful DHC2 Beaver STOL utility transport. Dubbed the "King Beaver" during design, it would be the veritable "one-ton truck" to the Beaver's "half-ton" role.[1]
The Otter received Canadian certification in November 1952 and entered production shortly thereafter. Using the same overall configuration as the Beaver, the new, much heavier design incorporated a longer fuselage, greater-span wing, and cruciform tail. Seating in the main cabin expanded from six to 10 or 11. Power was supplied by a 450-kW (600hp) Pratt & WhitneyR-1340 geared radial. The version used in the Otter was geared for lower propeller revolutions and consequently lower airspeed. The electrical system was 28 volts D.C.
Like the Beaver, the Otter can be fitted with skis or floats. The Otter served as the basis for the very successful Twin Otter, which features two wing-mounted Pratt & Whitney Canada PT6 turboprops. A total of 466 Otters were manufactured.[2]
U.S. Army U-1A, July 1967 Hue Citadel Airfield, Republic of VietnamOtter on floats, powered by a PZL Kalisz ASz-62IR with four blade propellerF/L Lynn Garrison and crew with UNEF Otter, Sinai, 1962Turbo Otter on wheel-skisU.S. Navy U-1B (UC-1) Otter at NAS Pensacola, Florida, in 2002Otter with turbine engine conversion, covered against the cold on Mistassini lake, Mistissini, Quebec
The DHC-3/CC-123/CSR-123 Otter was used until 1980 by the Royal Canadian Air Force and its successor, the Air Command of the Canadian Forces. It was used in Search and Rescue, as the "CSR" denotes Canadian Search (and) Rescue (type 123) and as a light utility transport, "CC" denoting Canadian Cargo.
During the Suez Crisis, the Canadian government decided to provide assistance to the United Nations Emergency Force and the Royal Canadian Navy carrier HMCSMagnificent carried 4 Otters from Halifax to Port Said in Egypt early in 1957, with all four flying off unassisted while the ship was at anchor.[3] This was the only occasion when RCAF fixed wing aircraft operated from a Canadian warship.[3]
It was also operated on EDO floats on water and skis for winter operations on snow. The EDO floats also had wheels for use on runways (amphibious). It was used as army support dropping supplies by parachute, and also non-parachute low-speed, low-altitude air drops, to support the Canadian Army on manoeuvres. In the end it was operated by the Primary Air Reserve in Montreal, Toronto, Edmonton and Winnipeg, with approximately 10 aircraft at each base, as well as by the RSU (Regular (Forces) Support Units) at those bases. It was usually flown with a single pilot (Commissioned Officer) in the left seat and a Technical Air Crewman (NCO) in the right seat. The Kiowa helicopter replaced it in Air Reserve squadrons.
Although the Otter found ready acceptance in bush airlines, as in a similar scenario to the DHC-2 Beaver, the United States Army soon became the largest operator of the aircraft (184 delivered as the U-1A Otter). Other military users included Australia, Canada, and India, but the primary role of the aircraft as a rugged bush plane continues to this day.
Otters were used by Qantas from 1958 to 1960 in Papua New Guinea. The Qantas aircraft were then transferred to Trans Australian Airlines (TAA), a major Australian domestic airline, which operated the Otters in Papua New Guinea until 1966 when they were withdrawn from use. TAA was merged with Qantas in 1990.
Modifications
The most extensively modified Otter was RCAF Otter 3682. After initial service as a standard Search and Rescue aircraft it was used to explore the aerodynamic aspects of STOL. In 1958, it was fitted with flaps so outsized that, with their 45 degree droop, it became known as the Batwing Otter. In addition, its tail-wheel undercarriage was replaced with a high energy-absorption 4-wheel arrangement and a very high vertical tail. The next modification replaced the flaps with fully retractable flaps suitable for cruising flight and high drag was obtained with reverse thrust from a J85 turbojet installed in the fuselage behind the cockpit. The third configuration looked a lot like the future Twin Otter and was the first twin-PT6 fixed-wing installation to fly in May 1963 (A twin PT6-engined helicopter, the Kaman K-1125, had flown in April 1963). The piston engine in the nose was replaced with wing-mounted engines to blow over the flaps.[4][5][6]
Stolairus Aviation of Kelowna, BC, has developed several modifications for the DHC-3 including a STOL Kit, which modifies the wing with a contoured leading edge and drooped wingtips for increased performance. Stolairus has also developed a 180 kilograms (400lb) "upgross" kit which increases the gross weight of the DHC-3 to 3,795 kilograms (8,367lb) on floats.[7]
A Polish PZLradial engine has also been fitted. Re-engined aircraft have been offered since the 1980s by Airtech Canada as the DHC-3/1000 using current-production 1,000hp (745kW) PZL ASz-62 IR radials.[8]
Royal Australian Air Force: Two Otters (RAAF serial A100-1 and 2) were in service with the RAAF from 1961 to 1967. The aircraft were used for passenger and freight transport duties at the Weapons Research Establishment, Woomera, South Australia.
As of June 2019, there have been 119 incidents and accidents involving the DHC-3 resulting in 242 deaths.[12] Listed below are a select few of the most notable ones.
In 1956, two military Otters broke up in mid-air. One had taken off from Downsview and the other from Goose Bay. The Otter requires immediate use of elevator trim to counteract the strong change in pitch caused by the retraction or extension of the flaps. Investigators found that metal contamination in a hydraulic valve allowed the flaps to rapidly retract with the tailplane still fully trimmed, and the consequent nose drop was severe enough to cause structural failure. A filter was added to the flap hydraulic system and an interconnection added between the flaps and tailplane to maintain proper trim as the flaps are operated.[13]
On 22 June 1994, a DHC-3 Otter floatplane, N13GA, registered to and operated by Wings of Alaska of Juneau, Alaska, crashed into the Taku Inlet, 12 miles east of Juneau. The air taxi flight had departed the Taku Lodge located on the Taku River bound for the Juneau downtown dock. Instrument meteorological conditions prevailed at the time of the accident. Six passengers were killed, one passenger was missing and presumed dead, and the pilot and three passengers received serious injuries. The National Transportation Safety Board (NTSB) attributed the accident to continued VFR into IMC and the pilot's consequent failure to maintain altitude above the water surface.[14]
On 9 August 2010, a DHC-3T registered to Anchorage-based GCIcrashed about 17 miles (27km) north of Dillingham, Alaska, while en route to a private fishing lodge.[15] Five of the nine people on board were killed, including former Alaska Senator Ted Stevens. Surviving passengers included former NASA administrator Sean O'Keefe and his teenage son, both of whom sustained injuries.[16]
On 23 September 2011, a DHC-3T Turbine Otter floatplane, N361TT, sustained substantial damage during a go-around and subsequent low-altitude maneuver at Heitman Lake, about 5 miles south-southwest of Kodiak, Alaska, killing the pilot and injuring the two passengers. One of the passengers reported that during the go-around, the airplane struck a tree on the shoreline and crashed.[17]
On 7 July 2013, a DHC-3 Otter registered to Rediske Air, N93PC, crashed on takeoff at Soldotna Airport, Alaska, killing all ten aboard.[18] There were no surviving witnesses and the aircraft did not carry a flight data recorder, but the NTSB was able to reconstruct the aircraft's flight path using a recovered mobile phone video recorded by a passenger. The NTSB attributed the accident to a stall caused by the operator's failure to weigh cargo and verify that the aircraft was loaded within its center of gravity limits.[19]
Debris of 2015 Promech Air crash near Ketchikan, Alaska On 25 June 2015, a Promech Air DHC-3 Otter crashed into the face of a granite cliff near Ella Lake, Alaska, 20 miles (32km) northeast of Ketchikan. The aircraft carried a pilot and eight passengers who were tourists on a sightseeing excursion from a Holland America Line coastal cruise aboard the cruise shipMS Westerdam. All nine people on board died. The NTSB determined that the pilot had a history of poor decision making and that the company had a compromised culture that resulted in an "operation in which safety competed with performance and revenue".[20][21][22][23]
On 15 September 2015, a DHC-3 Turbine Otter floatplane carrying ten people and belonging to Rainbow King Lodge crashed on takeoff at Eastwind Lake, 1mi (1.6km) mile north of Iliamna, 175mi (282km) southwest of Anchorage. Three people were killed in the crash.[24]
On 13 May 2019, in the 2019 Alaska mid-air collision, a Taquan Air DHC-3 Turbine Otter floatplane, N959PA, collided with a Mountain Air Service DHC-2 Beaver, N952DB, over George Inlet, Alaska, with the loss of one passenger aboard the DHC-3 and five passengers and crew aboard the DHC-2. The NTSB attributed the accident to "'the inherent limitations of the see-and-avoid concept, along with the absence of alerts from both airplanes' traffic display systems." Due to the angle of approach, both pilots' viewpoints were partially blocked by the aircraft structure or seated passengers. The NTSB identified Taquan's inadequate preflight checklist and the Federal Aviation Administration's failure to require Taquan to implement a safety management system as contributing factors.[25]
On 4 September 2022, a DHC-3 floatplane operated by Friday Harbor Seaplanes, N725TH, crashed in Puget Sound near Whidbey Island, Washington, killing all ten aboard the aircraft.[26] On October 24, the NTSB announced that the horizontal stabilizer actuator had separated into two pieces at a threaded assembly fitting, and that the actuator lock ring was missing from the wreckage.[27][28] The next day, Viking Air issued a service letter requiring DHC-3 Otter operators to inspect their aircraft and ensure that the actuator's lock ring is present.[29]
3-view line drawing of the de Havilland Canada U-1A Otter
Data from Jane's All the World's Aircraft 1958–59,[30] Jane's Civil and Military Aircraft Upgrades 1994–95[31]
General characteristics
Crew: 1 or 2
Capacity: 9–11 passengers (optional 10th seat in main cabin) / 6 stretchers with 4 seats / 2-3 stretchers with 7 seats
Hayes, Karl E. DHC-3 Otter – A History (CD-ROM). Crakaig, Killiney Hill Road, Killiney, Co. Dublin, Ireland: Karl E. Hayes Publisher, 2006. (also available via CANAV Books, Toronto)
Hotson, Fred W. The de Havilland Canada Story. Toronto: CANAV Books, 1983. ISBN0-07-549483-3.
Michell, Simon. (ed.). Jane's Civil and Military Aircraft Upgrades 1994–95. Coulsdon, UK: Jane's Information Group, 1994. ISBN0-7106-1208-7.
Molson, Ken M. and Harold A. Taylor. Canadian Aircraft Since 1909. Stittsville, Ontario: Canada's Wings, Inc., 1982. ISBN0-920002-11-0.
"Pentagon Over the Islands: The Thirty-Year History of Indonesian Military Aviation". Air Enthusiast Quarterly (2): 154–162. n.d. ISSN0143-5450.
Rossiter, Sean. The Immortal Beaver: The World's Greatest Bush Plane. Vancouver: Douglas & McIntyre, 1999. ISBN1-55054-724-0.
Rossiter, Sean. Otter & Twin Otter: The Universal Airplanes. Vancouver: Douglas & McIntyre, 1998. ISBN1-55054-637-6.
Sonck, Jean-Pierre (January 2002). "1964: l'ONU au Congo" [The United Nations in the Congo, 1964]. Avions: Toute l'Aéronautique et son histoire (in French) (106): 31–36. ISSN1243-8650.
Sonck, Jean-Pierre (February 2002). "1964: l'ONU au Congo". Avions: Toute l'Aéronautique et son histoire (in French) (107): 33–38. ISSN1243-8650.
Taylor, John W.R., ed. Jane's All The World's Aircraft 1988–89. Coulsdon, UK: Jane's Defence Data, 1988. ISBN0-7106-0867-5.
.jpg)
.jpg)
