The Fairchild PT-19 (company designation Fairchild M62) is an American monoplane primary trainer aircraft that served with the United States Army Air Forces, RAF and RCAF during World War II. Designed by Fairchild Aircraft, it was a contemporary of the Kaydet biplane trainer, and was used by the USAAF during Primary Flying Training. As with other USAAF trainers of the period, the PT-19 had multiple designations based on the powerplant installed.
 | This article needs additional citations for verification. (September 2024) |
| PT-19 | |
|---|---|
 Fairchild PT-19 | |
| General information | |
| Type | Trainer |
| Manufacturer | Fairchild Aircraft |
| Primary users | United States Army Air Corps |
| Number built | 7,700+ |
| History | |
| Introduction date | 1940 |
| First flight | 15 May 1939 |
Design and development
According to H.L. Puckett, "Still U.S. pilots were receiving their primary flight training in biplanes, although the low wing advance trainer was in use. A look around showed that there was no low wing primary trainer being produced in the U.A. Fairchild felt this urgency and set his organization at work on such a low wing trainer with the proposal that the new proven Ranger be used as the power plant for the new airplane to be known as the M-62. The M-62, which was to become the PT-19, was to use the experience gained from the F-24 and the more recent Model 46."[1]
In 1933, Fairchild Aircraft Corporation's chief engineer, A.A. Gassner, had hired Armand Thiebolt, as his chief structural engineer. In 1937, Thiebolt was named chief engineer, and given the task of designing the PT-19. Included in the design was the use of interchangeable parts and non-strategic materials. According to Puckett, "The proposed low wing design adapted itself readily to a wide tread landing gear, which when combined with judicious wheel location and a low center of gravity, provided protection against ground looping." The Ranger engine would also result in a narrower cowling compared to those using a radial engine, which meant increased visibility for the pilot. The reduced cowling also improved propeller efficiency and an increase in horsepower.[1]
The cantilever wings, with wooden ribs, were covered by 3/32 inch preformed mahogany or fir plywood. The inboard portion consisted of a welded trussed 4130 structure. The fuselage used Chromoly square tubing for the longerons and brace members, and fabric covered. The cowling was made of Alclad. Both wing center sections contained the 24.5-US-gallon (93 L) fuel tank, with landing gear housings on the outboard ends. The oleo struts were designed to withstand a 6 g acceleration from a 30-inch (76 cm) drop. Two hollow box wood spars were used in the wing and center sections. Duramold was used to cover the wings. Early models used aluminum alloy seats made by the Budd Company, while later models used plywood seats made by Hughes Aircraft Company. Early models had metal floors and flaps, while later models used wood for both. The vertical and horizontal stabilizers were made of spruce spars, covered with 1⁄16 inch (1.6 mm) plywood. According to Puckett, "Moisture became the arch enemy of the Fairchild PT and was responsible for the relatively small survival rate of the airplanes built."[1]
On 15 May 1939, the M-62 prototype first flew. In a fly-off competition at Wright Field, the aircraft beat out 17 other designs. On 22 September 1939, the Army placed an order for 270 airplanes. Fairchild had to include 27 wood working subcontractors, including furniture stores, a hosiery plant and a foundry. After the start of WWII, Fairchild licensed manufacturing with Fleet Aircraft, Howard Aircraft Corporation, St. Louis Aircraft Corporation, and Aeronca.[1]
The original production batch of 275 were powered by the inline 175 hp Ranger L-440-1 engine and designated the PT-19.[citation needed] In 1941, mass production began and 3,181 of the PT-19A model, powered by the 200 hp L-440-3, were made by Fairchild. An additional 477 were built by Aeronca and 44 by the St. Louis Aircraft Corporation. The PT-19B, of which 917 were built, was equipped for instrument flight training by attaching a collapsible hood to the front cockpit.
When airplane production exceeded engine production, the PT-23 was prototyped by Fairchild. Except for the engine, the airplane was identical from the firewall rearwards. According to Puckett, "The second protype PT-23 was the only one of these airplanes which was painted Air Corps blue and yellow."[1] The PT-23 was powered by the 220 hp Continental R-670 radial powerplant. A total of 869 PT-23s were built as well as 256 of the PT-23A, which was the instrument flight-equipped version.[citation needed] The PT-23 was manufactured in the US by Fairchild, Aeronca, St. Louis Aircraft Corporation and Howard Aircraft Corporation and in Canada by Fleet Aircraft Corporation as well as Fabrica do Galeao in Brazil (220 or 232 between 1944 and 1948).
During 1943, USAAF Training Command received a number of complaints about durability issues with the plywood wings of the PT-19 and the PT-23 when exposed to the high heat and/or humidity of training bases located in Texas and Florida.[2] Maintenance officers at the USAAF overhaul depots had been forced to order replacement of the wooden wing sections after only two to three months' active service because of wood rot and ply separation issues.[2] Subsequent to this incident, the USAAF incorporated a demand for all-metal wing sections on all future fixed-wing training aircraft.[2]
The final variant was the PT-26 which used the L-440-7 engine. The Canadian-built versions of these were designated the Cornell for use by the British Commonwealth Air Training Plan which was centered in Canada.[citation needed]
Operational history
|
Compared to the earlier biplane trainers, the Fairchild PT-19 provided a more advanced type of aircraft. Speeds were higher and wing loading more closely approximated that of combat aircraft, with flight characteristics demanding more precision and care. Its virtues were that it was inexpensive, simple to maintain and, most of all, virtually viceless.[citation needed]
These planes were delivered to various bases all over the country by WASPs (Women's Airforce Service Pilots) between 1942-1944.[citation needed]
Thousands of the PT-19 series were rapidly integrated into the United States and Commonwealth training programs, serving throughout World War II and beyond. Even after their retirement in the late 1940s, a substantial number found their way onto the United States and other civil registers, being flown by private pilot owners.[citation needed]
Variants
- PT-19
- Initial production variant of the Model M62 powered by 175 hp L-440-1, 270 built.
- PT-19A
- As the PT-19 but powered by a 200 hp L-440-3 and detailed changes, redesignated T-19A in 1948, 3226 built.
- PT-19B
- Instrument training version of the PT-19A, 143 built and six conversions from PT-19A.
- XPT-23A
- A PT-19 re-engined with a 220 hp R-670-5 radial engine.
- PT-23
- Production radial-engined version, 774 built.
- PT-23A
- Instrument training version of the PT-23, 256 built.
- PT-26
- PT-19A variant with enclosed cockpit for training in Canada under the British Commonwealth Air Training Plan, powered by a 200hp L-440-3, 670 built for the Royal Canadian Air Force as the Cornell I.
- PT-26A
- As PT-26 but with a 200hp L-440-7 engine, 807 built by Fleet as the Cornell II.
- PT-26B
- AS PT-26A with minor changes, 250 built as the Cornell III.
- Cornell I
- RCAF designation for the PT-26.
- Cornell II
- RCAF designation for the PT-26A.
- Cornell III
- RCAF designation for the PT-26B.
Operators
- Honduran Air Force - PT-23[11]
- Paraguayan Air Arm received a few Fairchild M-62s in 1940, followed by 15 Lend-Lease PT-19A in 1942-43.[14] In the 1950s, 14 ex-Brazilian Air Force PT-19s (PT-3FG built under license in Brazil) were received. The last PT-19 was retired in 1972.[citation needed]
- Uruguayan Air Force received 17 PT-19As and PT-19Bs under Lend Lease in 1942, with 50 PT-26s being delivered in 1946–1947.[17]
- Uruguayan Navy[18]
- Aviación Militar received 20 PT-19As under Lend Lease.[19]
Surviving aircraft
.jpg)
As of 2011[update], there were 98 airworthy aircraft worldwide.[20]
- One example is found at the Travis Air Force Base Aviation Museum, Travis Air Force Base, Fairfield, California.[21]
- Another is in storage at the Reynolds-Alberta Museum in Wetaskiwin, Alberta.[22]
- Fairchild PT-26A-FE Cornell II 'N58799' is flying in the Netherlands[23]
- Fairchild PT-19A (283435) is flying in Alabama with the Birmingham Escadrille of the Commemorative Air Force after a 22 year restoration started in 1986.[24][25]
Specifications (PT-19A)
Data from United States Military Aircraft since 1909[26]
General characteristics
- Crew: two (pilot, student)
- Length: 28 ft 0 in (8.53 m)
- Wingspan: 36 ft 0 in (10.97 m)
- Height: 10 ft 6 in (3.20 m)
- Wing area: 200 sq ft (19 m2)
- Empty weight: 1,845 lb (837 kg)
- Gross weight: 2,545 lb (1,154 kg)
- Powerplant: 1 × Ranger L-440-3 6-cyl. inverted air-cooled in-line piston engine, 200 hp (150 kW)
Performance
- Maximum speed: 115 kn (132 mph, 212 km/h)
- Range: 350 nmi (400 mi, 640 km)
- Service ceiling: 15,300 ft (4,700 m)
- Time to altitude: 17.5 min to 10,000 feet (3,000 m)
See also
Related development
- Fairchild M-62
Aircraft of comparable role, configuration, and era
Related lists
Notes
Bibliography
External links
Wikiwand in your browser!
Seamless Wikipedia browsing. On steroids.
Every time you click a link to Wikipedia, Wiktionary or Wikiquote in your browser's search results, it will show the modern Wikiwand interface.
Wikiwand extension is a five stars, simple, with minimum permission required to keep your browsing private, safe and transparent.
