Loading AI tools
哈特莱振荡器 来自维基百科,自由的百科全书
哈特萊振盪器(英語:Hartley oscillator),又稱赫特利振盪器,電感三點式振盪器[1],是一種由電容和電感的調諧電路(即LC振盪器)決定振盪頻率的電子振盪器電路。該電路是美國工程師雷夫·哈特萊於1915年發明的。Hartley振盪器的特點是調諧電路由一個電容器與串聯的兩個電感(或單抽頭電感)並聯,振盪所需的反饋信號取自兩電感連接的中心。
此條目目前正依照其他維基百科上的內容進行翻譯。 (2018年1月16日) |
Hartley振盪器的突出特點是諧振電路包含兩個串聯線圈(或者通常用抽頭線圈)與電容器並聯,在相對高阻態的LC槽電路和線圈間,相對低電壓/高電流點之間有一個放大器。
1905年的原始版本使用一個三極管作為屏極接地(陰極跟隨器)組態中的放大器件,含有三節電池,以及獨立可調線圈。右圖顯示的簡化電路使用一個JFET(共汲極極組態)、一個LC諧振電路(這裏的單繞組是抽頭的)和一個單電池。該電路說明了Hartley振盪器的操作:Circuit operation[可疑]
Variations on the simple circuit often include ways to automatically reduce the amplifier gain to maintain a constant output voltage at a level below overload; the simple circuit above will limit the output voltage due to the gate conducting on positive peaks, effectively damping oscillations but not before significant distortion (spurious harmonics) may result. Changing the tapped coil to two separate coils, as in the original patent schematic, still results in a working oscillator but now that the two coils are not magnetically coupled the inductance, and so frequency, calculation has to be modified (see below), and the explanation of the voltage increase mechanism is more complicated than the autotransformer scenario.
A quite different implementation using a tapped coil in an LC tank feedback arrangement, still called a Hartley oscillator (or sometimes "the" Hartley Oscillator circuit[2]) is to employ a common-grid (or common-gate or common-base) amplifier stage, which is still non-inverting but provides voltage gain instead of current gain; the coil tapping is still connected to the cathode (or source or emitter), but this is now the (low impedance) input to the amplifier; the split tank circuit is now dropping the impedance from the relatively high output impedance of the plate (or drain or collector).
The Hartley oscillator is the dual of the Colpitts oscillator which uses a voltage divider made of two capacitors rather than two inductors. Although there is no requirement for there to be mutual coupling between the two coil segments, the circuit is usually implemented using a tapped coil, with the feedback taken from the tap, as shown here. The optimal tapping point (or ratio of coil inductances) depends on the amplifying device used, which may be a bipolar junction transistor, FET, triode, or amplifier of almost any type (non-inverting in this case, although variations of the circuit with an earthed centre-point and feedback from an inverting amplifier or the collector/drain of a transistor are also common), but a junction FET (shown) or triode is often employed as a good degree of amplitude stability (and thus distortion reduction) can be achieved with a simple grid leak resistor-capacitor combination in series with the gate or grid (see the Scott circuit below) thanks to diode conduction on signal peaks building up enough negative bias to limit amplification.
振盪頻率約為槽電路的諧振頻率。若槽路電容器的電容為 C 而抽頭電感的總電感是 L,則
若使用了電感為 L1 和 L2 兩個非耦合的線圈
由於線圈中的寄生電容和電晶體的負載,實際振盪頻率將略低於上述。
Hartley振盪器的優點包括:
缺點包括:
Seamless Wikipedia browsing. On steroids.
Every time you click a link to Wikipedia, Wiktionary or Wikiquote in your browser's search results, it will show the modern Wikiwand interface.
Wikiwand extension is a five stars, simple, with minimum permission required to keep your browsing private, safe and transparent.