The EMD FL9 (New Haven Class EDER-5) is a model of electro-diesel locomotive, capable of operating either as a traditional diesel-electric locomotive or as an electric locomotive powered from a third rail. Sixty units were built between October 1956 and November 1960 by General Motors Electro-Motive Division for the New York, New Haven and Hartford Railroad (the "New Haven").[1]

Quick Facts Type and origin, Power type ...
EMD FL9
New Haven FL9 No. 2010 at Enfield in 1968
Type and origin
Power typeElectro-diesel
BuilderGeneral Motors Electro-Motive Division (EMD)
ModelFL9
Build dateOctober 1956 – November 1960
Total produced60
Specifications
Configuration:
  AARB-A1A
  UICBo'(A1A)
Gauge4 ft 8+12 in (1,435 mm)
Length60 ft 0 in (18.29 m)
Loco weight287,000 lb (130,000 kg)
Electric system/s660 V DC Third rail
Current pickup(s)Contact shoe
Prime moverEMD 16-567C (2000–2029),
EMD 16-567D1 (2030–2059)
Engine typeV16 Two-stroke diesel
AspirationRoots blower
Displacement9,072 cu in (148.663 L)
GeneratorDC generator
Traction motorsDC traction motors
Cylinders16
Cylinder size8.5 in × 10 in (216 mm × 254 mm)
TransmissionElectric
Loco brakeStraight air, original 24RL later 26C
Train brakesAir
Performance figures
Maximum speed89 mph (143 km/h)
Power output567C: 1,750 hp (1,300 kW),
567D1: 1,800 hp (1,300 kW)
Tractive effort53,200 lbf (236.6 kN) (Starting)
29,500 lbf (131.2 kN) (Continuous) @ 9.3 mph
Career
OperatorsNew Haven, Penn Central, Amtrak, Conrail, ConnDOT, Metro-North
ClassEDER-5 (2000-2029),
EDER-5a (2030-2059)
LocaleNorth America
DispositionRetired from Metro North and ConnDOT, some in service in museums and excursion trains
Close

Design

Due to concerns about diesel emissions in the East River Tunnels and the underground tracks of Grand Central Terminal and Penn Station, passenger trains entering New York City have long been required to use electrical power, as coal and later diesel exhaust would pose a hazard to human health in the confined underground spaces. At the same time, much of the New Haven's trackage was not electrified beyond New Haven. To allow passenger trains to travel to New York City from non-electrified lines without requiring a change of locomotives, the New Haven Railroad purchased a class of locomotive that could switch between diesel and electric power on the fly.

EMD's answer was a new locomotive based on their existing FP9, but lengthened to accommodate additional equipment, such as a larger train heating steam boiler and third rail contact shoes. Due to the additional weight, the locomotive was equipped with a three-axle rear truck, giving it an uncommon B-A1A wheel arrangement. Flexicoil trucks were used due to this type of truck having more room for fitting the third rail shoes.[2]

For electric operation, the FL9 was capable of using either an over-running or under-running third rail by means of retractable shoes operated by pneumatic cylinders. The first 30 locomotives also had a small DC pantograph for use within New York City's Grand Central Terminal, where long gaps exist in the third rail because of the complex trackage that includes numerous railroad switches.[3] For operation into the Pennsylvania Railroad's Pennsylvania Station, the FL9 used the Long Island Rail Road's third rail system.[4]

The electrical supply available from the third rail—660 V DC—was identical to the requirements of diesel locomotive traction motors, enabling a fairly easy conversion to a dual-power locomotive. A DC electric compressor provided air for the brake system until the diesel engine was started.[citation needed] Two batches of FL9s were built; an initial 30 (including the original test units 2000 and 2001, originally built with a Blomberg front truck, but later upgraded following testing) from October 1956 through November 1957 with the older 1,750 hp (1,305 kW) V16 EMD 567C engine; and an additional 30 between June and November 1960 with the newer 1,800 hp (1,342 kW) V16 EMD 567D1 engine.[5][6] All units were painted in the bright McGinnis scheme of red-orange, black and white and the Herbert Matter designed "NH" logo. FL9s were initially fitted with the Hancock air whistle, a trademark of New Haven units of this time, instead of the standard air horns on diesel locomotives.[citation needed]

Operation

New Haven trackage between Woodlawn and New Haven, Connecticut, 72 miles east from Grand Central, was electrified in the early 1900s at 11,000 volts, 25 Hz AC overhead. The New Haven was the pioneer of heavy mainline railroad electrification in the United States. Early plans to extend the catenary to Boston were never completed due to the perennial financial problems that plagued the New Haven almost continuously from the 1920s to its demise in 1969. This left a gap between New Haven and Boston, requiring trains between those cities to stop in New Haven to switch between diesel and electric locomotives. This extended travel time, which the New Haven sought to reduce.

The FL9s allowed through passenger trains from Grand Central Terminal to reach Boston, Springfield, and other non-electrified destinations without the need for an engine change at New Haven. They were purchased with the intent of allowing the eventual elimination of all New Haven electric locomotives and the abandonment of the electrification east of Stamford, Connecticut, 33 miles from Grand Central. The fact that the entire New York to Boston line is now electrified shows the short-sightedness of this concept, which had been adopted by the McGinnis management to avoid the cost of modernizing the New Haven's Cos Cob, Connecticut power plant. The New Haven to Boston electrification was finally completed by Amtrak in 1999.

Prior to the introduction of the FL9, all non-multiple unit New Haven passenger trains were hauled by electric locomotives between New York and New Haven, with a change to steam (before 1950) or diesel at New Haven. Meeting the weight limits of the Park Avenue Viaduct in Manhattan, the FL9 made it possible to eliminate the engine change and allow trains to reach Grand Central in less time. FL9s were used on the New Haven's premier name train, the Merchants Limited, which covered the 229.5 miles between Grand Central Terminal and South Station, Boston in 4 hours 15 minutes.

Introduction of the FL9 allowed the New Haven to scrap its entire fleet of pre-1955 electric locomotives, many of which were less than 25 years old. The FL9 had higher operating costs and lower performance than the electric locomotives it replaced, but was more flexible as it could go where electric locomotives could not. The only New Haven electrics surviving through the FL9 period were the General Electric EP5 "Jets" of 1955 as well as the freight service General Electric E33s purchased secondhand from the Virginian Railway in 1959. Even though one EP5 was as powerful as three FL9s, the powerful "Jets" were doomed by poor maintenance, and the last were retired in 1977, after having been regeared for freight service by inheritor Penn Central in 1973. In keeping with the New Haven's policy of dual service utilization of locomotives, FL9s were used at night to move a Trailer-on-FlatCar (TOFC) train, with difficulty, in one direction between Cedar Hill Yard in New Haven and Oak Point Yard in The Bronx. Assigned to this train in the other direction, an EP5 locomotive could easily outrun automobile traffic on the adjacent Connecticut Turnpike.

Thumb
The "Farewell to the FL9" excursion train.

The FL9s were considered to be under-powered compared to the powerful electrics they replaced, which also had their problems. For other reasons, the New Haven never abandoned its electrification, negating the primary reason for purchasing the FL9s. Their ability to avoid the engine change in New Haven allowed them to remain in service on trains that travelled in non-electrified territory, and they could also be operated like conventional diesel locomotives.

Penn Central and beyond

In 1969, the New Haven FL9 fleet passed to Penn Central upon the merger of the Pennsylvania Railroad and New York Central Railroad, as the ICC required the newly formed company to assume control of the bankrupt New Haven. Some were repainted in Penn Central schemes, while others remained in their former New Haven paint. When the New York Metropolitan Transportation Authority (MTA) began funding these commuter services in 1970, many were repainted blue with a bright yellow nose, although they remained Penn Central-owned. The locomotives passed to Conrail upon its formation in 1976 from the bankrupt PC. Twelve FL9s were sold to Amtrak, six of which were remanufactured by Morrison-Knudsen starting in 1978 and remained in Amtrak service until at least 1996.

In 1983, Conrail passed its commuter operations to state agencies. In New York State, the MTA formed Metro-North Railroad as a subsidiary company to operate these, and operations in Connecticut under contract with that state. The locomotives were repainted in Metro-North colors (more commonly in a silver, blue, and red scheme;[7] some in a silver and blue scheme[8]), and a large number of them, now in some cases over 25 years old, were rebuilt and modernized. Ten rebuilt for the Connecticut Department of Transportation (CDT) were painted in the original New Haven paint scheme in recognition of their original operator. This tradition has continued with other remanufactured locomotives in the CDT's Shore Line East service pool, as well as on four new GE Genesis II P32AC-DM dual-mode locomotives and six Brookville BL20GH Diesel-electric locomotives.

By the beginning of the 21st century, the worn-out FL9s were approaching a service life of 50 years and were gradually replaced by newer, more powerful locomotives. The FL9s were restricted to branch lines near the end of their lives since they lost the ability to operate on third rail power. Metro-North and Connecticut DOT, along with the Housatonic Railroad, operated a "Farewell to the FL9's" fan trip from Stamford, CT to Canaan, CT and return on October 23, 2005. The last FL9 to see passenger service was in late 2009, the same year Metro-North retired all its remaining FL9s. Six ConnDOT-owned locomotives were sold to other operators or museums by the end of 2018.[9][10]

The dual-power concept pioneered by the FL9 has been continued by the P32AC-DM and EMD DM30AC, both which remain on Amtrak, Metro-North and the Long Island Rail Road.

Original owners

More information Railroad, Quantity ...
RailroadQuantityRoad numbers
New York, New Haven and Hartford Railroad602000–2059
Close

Surviving examples

Thumb
Two FL9s preserved at the Danbury Railway Museum. The FL9 in the background wears an ahistorical New York Central Railroad livery.

Several FL9s exist today, donated to several museums and railways.

In 1978, FL9 #5048 was used in the filming of the original Superman movie starring Christopher Reeve. Still painted in New Haven livery, the unit was depicted pulling a commuter train past the entrance to Lex Luthor's hideout during the villain's introduction scene.[19]

See also

References

Further reading

Wikiwand in your browser!

Seamless Wikipedia browsing. On steroids.

Every time you click a link to Wikipedia, Wiktionary or Wikiquote in your browser's search results, it will show the modern Wikiwand interface.

Wikiwand extension is a five stars, simple, with minimum permission required to keep your browsing private, safe and transparent.